AlfaRadio AlfaSpid Rotator and Controller Manual de usuario descargar pdf (Pagina 13)



Page 13 of 20 file ~alfaspid/md-01/AlfaSpid_MD-01_Operation_15April2013_Master.doc April 15, 2013

11211 - 154 St. Edmonton, Alberta, Canada T5M 1X8 sales@alfaradio.ca 780 466 5779 www.alfaradio.ca

Mouse Control

If you have a specially designed mouse by SPID (RAS Mouse), you can connect

it to the MD-01 controller on OUT3 port (13 in back picture of MD01).

The mouse works if you set this option to ON.

External control (CONTROL xx)

This parameter specifies the communication port that is used to

control the connected motors. This parameter is not available when

template 1: NC, 2: NC is chosen.

If template 1: AZ, 2: AZ, is chosen, the motor can be controlled from

either of two ports.

The Controller display will show one or two descriptions depending on

the selected motor template:

• CONTROL A1 – motor template 1:AZ, 2:NC or 1:AZ, 2:AZ,

• CONTROL E2 – motor template 1:NC, 2:EL,

• CONTROL AE – motor template 1:AZ, 1:EL,

• CONTROL A2 – motor template 1:AZ, 2:AZ.

CONTROL parameter value:

• NONE - no external control. Motor controlled manually with buttons

on the controller,

• COM 0 - external control with selected protocol. Can also be

controlled manually,

• COM 1 - external control with selected protocol. Can also be

controlled manually,

• USB - controlled through USB D with selected protocol. Can also be

controlled manually,

• ETH - controlled through ETHERNET with selected protocol. Can also

be controlled manually.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

AlfaRadio AlfaSpid Rotator and Controller Manual de usuario Pagina 13