AlfaRadio AlfaSpid Rotator and Controller Manual de usuario descargar pdf (Pagina 8)



Page 8 of 20 file ~alfaspid/md-01/AlfaSpid_MD-01_Operation_15April2013_Master.doc April 15, 2013

11211 - 154 St. Edmonton, Alberta, Canada T5M 1X8 sales@alfaradio.ca 780 466 5779 www.alfaradio.ca

Operation

MD-01 Controller may be operated from the front panel keyboard or a

computer connected to one of the Communication ports.

MD-01 Controller has two modes (MODE).

• NORMAL – normal mode.

• MOTOR ANGLES – calibration mode.

To change the mode, use the [F] key.

Normal mode (NORMAL)

In this mode, the Controller may be operated with the [Right], [Left], [Up]

and [Down] buttons or receive commands from a Computer. The Controller

supports communications protocols such as SPID ROT1, SPID ROT2, and YAESU

which can be assigned to any communications port (COM 0, COM 1, USB D and

ETH) in the settings. YAESU mode may not support the full capability of

AlfaSpid

rotators.

The [Right] and [Left] buttons are used to rotate the antenna in the

azimuth.

The right direction – the antenna turns in a clockwise direction, the value

of the angle in the display increases.

The left direction – the antenna turns in an anticlockwise direction, the

value of the angle in the display decreases.

The [Up] and [Down] buttons are used to rotate the antenna in the

elevation.

The up direction – the rotator turns right from the point of view of the

front. The value of the angle in the display increases.

The down direction – the rotator turns left from the point of view of the

front. The value of the angle in the display decreases.

The directions of antenna rotation are shown in the picture:

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Sin comentarios

AlfaRadio AlfaSpid Rotator and Controller Manual de usuario Pagina 8